HFD1 and HFD2 Installation Kit
DRILL GUIDE
After removing the necessary bark the drill guide is attached to the tree with a velcro strap. For additional information about installation, please check the HFD Quick Start Guide
______________________________________________________________________________
1.9mm DRILL BITS
Drill bit for most installations.
______________________________________________________________________________
2.0mm DRILL BITS
The 2.0mm drill bit is used to clean holes in species where the xylem fibres have either not been easily and cleanly cut and relax back into the path way after drilling or surrounding fibres expand into the hole and rapidly closing up the pathway making insertion of the needles difficult.
______________________________________________________________________________
100mm MEASUREMENT NEEDLE SLEEVE
To be inserted into the drilled hole to aid in insertion and removal of the sensors.
______________________________________________________________________________
120mm MEASUREMENT NEEDLE SLEEVE
To insert into the drilled hole to aid in insertion and removal of the sensors. Note this sleeve is longer than the measurement needle sleeves specifically for the longer heater needle.
______________________________________________________________________________
INSERTION TOOL
To aid in the Insertion of the sleeves. You can use this also for SFM1 and SFM1x installations
______________________________________________________________________________
DOW CORNING VACUUM GREASE
Fill the 10 ml Offset Syringe with the grease to create a vacuum seal. You can use this also for PSY1 installations
______________________________________________________________________________
10ml OFFSET SYRINGE
Use the syringe filled with Silicon grease to smear around the whole of the wound, thus creating a vapour seal.
The total weight of the HFD1 and HFD2 Installation kit is under 1kg.
It is 330mm x 240mm x 60mm when packaged for shipping.
